LG ARTCOOL Series Service Manual page 46

7.3.7 Error code 08
Discription
• Indoor fan or motor is locked
• Short circuit inside the fan motor winding.
Supposed
Causes
• Fan connector is not connected to indoor unit PCB assembly
• Defective in DC-fan driving circuit
Supplied voltage to
Indoor PCB is about
AC 220/240V ?
Yes
Is indoor fan rotating ?
Yes
Is DC - fan driving circuit working
properly ?
Yes
Is DC - fan motor working
properly ?
No
* Check PCB.
- Operate the fan motor with another normal PCB. If the motor is rotate,
the PCB in the unit has problem. Replace the PCB in indoor unit.
CAUTION
Before working, please wait for some time to allow the capacitor to discharge fully.
Working on the equipment that is connected to a power supply can cause an electrical shock.
Please, connect and disconnect the fan motor wires to the PCB after disconnecting the power plug and then resume operation.
Be sure to disconnect the power cable plug from the plug socket before disassembling the
equipment for a repair. Internal components and circuit boards are at main potential when the
equipment is connected to the power cables. This voltage is extremely dangerous and may
cause death or severe injury if come in contact with it.
Be sure to turn off power switch before connect or disconnect connector, or parts damage may
be occurred.
Copyright ©2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Indoor fan is locked (BLDC fan model only)
No
Check power source
- remove obstacles in indoor unit
No
fan assembled correctly.
- CN-Motor1 & assembling state of
DC Fan connector.
No
* Check DC Fan Driving circuit
(Soldering state & Direction)
- R01F~R09F, C01F~C03F,
IC01F~IC03F, Q01F~Q02F, ZD01F
* Drive another motor with not replace.
If the motor is rotate ,The PCB is ok
Yes
Replace the motor in indoor unit.
- 45 -
Part 4 Trouble Shooting Guide
LGE Internal Use Only