Worx WX22AG Original Instructions Manual page 9

d) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully reenter the cut. The wheel may
bind, walk up or kickback if the power tool is
restarted in the workpiece.
e) Support panels or any oversized workpiece
to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under
their own weight. Supports must be placed under
the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel.
f) Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can cause
kickback.
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or
retailer for recycling advice.
Before any work on the machine itself,
pull the mains plug from the socket
outlet.
Wear protective gloves
Angle Grinder
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard
for cutting (accessory) must be used.
ASSEMBLY AND OPERATION
Action
Assembly
Assembling Auxiliary Handle
Wheel Guard for Grinding
The coded projection on the
Wheel Guard (14) ensures
that only a guard that fits the
machine type can be mounted.
Wheel Guard for Cutting
WARNING! For cutting
metal, always work with
the wheel guard for cutting.
Adjusting Guard
Adjusting Outer Flange Clamping
Rotating The Gear Case
Fitting the Disc
OPERATON
Holding the Hand Grip
Using Lock-off & lock-on switch
If you wish to use the tool
continuously, push the safety
switch lever (B) forward and
depress on/off switch (A) fully,
then push the safety switch lever
(B) forward again and release
the On/Off switch. Now your
switch has been locked on for
continuously use. To switch off
your tool, simply depress On/
Off switch fully, the safety On/Off
switch will automatically release.
Soft Start
Internal electronic components
allow the motor speed to
increase slowly, which reduces
the"twisting"effect on your
wrists due to the high power
motor.
Cutting
Brush Wear Indicator (WX22AG /
WX23AG/WX23AG.2)
Figure
See Fig. A1
See Fig. A2
See Fig. B
See Fig. C1 C2
See Fig. D
9
See Fig. E
See Fig. F
See Fig. G
See Fig. H
See Fig. I
EN