Advertisement
Available languages
Available languages
Auto-Stop Carbon Brush (Only
For WX23AG.1)
Replacing The Carbon Brush
Rough Grinding
WARNING! Never use a
cutting disc for roughing.
WORKING HINTS FOR YOUR
ANGLE GRINDER
1. Always start at no load to achieve maximum
speed then start working.
2. Do not force the disc to work faster, reducing the
Disc's moving speed means longer working time.
3. Always work with a 15-30 angle between disc and
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
4. When using a cutting disc never change the
cutting angle otherwise you will stall the disc
and angle grinder motor or break the disc. When
cutting, only cut in the opposite direction to the
disc rotation. If you cut in the same direction as
the disc rotation the disc may push itself out of
the cut slot.
5. When cutting very hard material best results can
10
be achieved with a diamond disc.
6. When using a diamond disc it will become very
hot. If this happens you will see a full ring of
sparks around the rotating disc. Stop cutting and
allow to cool at no load speed for 2-3 minutes.
7. Always ensure the workpiece is firmly held or
clamped to prevent movement.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Angle Grinder
TROUBLESHOOTING
See Fig. J
Although your new angle grinder is really very
simple to operate, if you do experience problems,
See Fig.K
please check the following:
1. If your grinder will not operate check the power at
2. If your grinder wheel wobbles or vibrates, check
3. If there is any evidence that the wheel is
4. If working on aluminum or a similar soft alloy,
ENVIRONMENTAL
PROTECTION
local authorities or retailer for recycling advice.
the main plug.
that outer flange is tight, check that the wheel is
correctly located on the flange plate.
damaged do not use as the damaged wheel may
disintegrate, remove it and replace with a new
wheel. Dispose of old wheels sensibly.
the wheel will soon become clogged and will not
grind effectively.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
EN
Advertisement
