Steps
1. Align the notch on the memory module with the tab on the memory module slot and slide the memory module firmly into the
slot at an angle.
2. Press down on the memory module to snap it into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
3. Ensure that the securing clips have locked the memory module into place.
NOTE:
If the securing clips are not locking the memory module into place remove the memory module from the slot and
repeat steps 1 and 2.
4. Repeat the procedure above for the second memory module, if applicable.
Next steps
1. Install the
base
cover.
2. Exit
service
mode.
3. Install the
SD
card.
4. Follow the procedure in
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Enter
service
mode.
4. Remove the
base
cover.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
29