Table of Contents
Advertisement
Problem solving guide
Display warnings
Message
The alarm symbol is
lit up in the display. The
three sensors for the
wine conditioning zones
are flashing in the con-
trol panel. An audible
alarm is also sounding.
The alarm symbol is
flashing in the display,
and the sensor for one
of the wine conditioning
zones is also flashing.
An alarm tone is also
sounding.
The Change Active
AirClean filter symbol
is lit up.
A dash is lit up up/flash-
ing in the display.
"F0" to "F3" or
"S1" to "S3" appear in
the display.
44
Cause and remedy
The door alarm has been activated.
Close the door. The three sensors for the wine
conditioning zones and the alarm symbol will
go out and the audible alarm stops.
The temperature in the zone concerned has risen
higher or fallen lower than the temperature set.
Possible reasons for this include:
– The appliance door has been opened too fre-
quently.
– The ventilation gaps have been blocked.
– A prolonged power cut (power outage) has oc-
curred.
Rectify the cause of the alarm. The alarm sym-
bol goes out and the sensor for the affected
wine conditioning zone lights up again constantly.
The alarm will stop.
This is the reminder to change the Active AirClean fil-
ters.
Replace the Active AirClean filters in all three wine
conditioning zones and then confirm the filter
change in settings mode (see "Active AirClean Fil-
ters").
Only temperatures within the range the wine condi-
tioning unit can display will be shown.
There is a fault.
Call Service.
Advertisement
Table of Contents
