Door Reversal; Special Accessories - Zanussi ZTE7101PZ User Manual

Hide thumbs Also See for ZTE7101PZ:
Table of Contents

Advertisement

Note that to prevent condensation problems, it is
essential that the dryer be installed with the flexible
hose to transmit its "exhaust" at least beyond the
kitchen units; preferable outside the kitchen. In
order to prevent the appliance from overheating, it
is important that the steam exhaust is unobstructed.
Thus, if a permanent hose installed to an external
wall or ceiling, it must be ensured an exhaust
capacity of minimum 150 m3/h. If the dryer is
installed adjacent to kitchen units, make sure that
the vent hose is not squashed. If the hose is not
fully squashed, drying efficiency will be decreased ,
resulting in longer drying times and higher energy
consumption. If the hose is fully squashed, the
automatic cut-outs with which the appliance is
fitted can operate. When operating the tumble
dryer, the room temperature must not be lower than
+5°C and higher than +35°C, as it can affect the
performance of the appliance.
If the hose is long and the room
temperature low, the moisture might
condense to water inside the hose.
This is an usual occurrence. To
prevent this water from the hose, it is
recommend to drill a small hole (via. 3
mm) in the lowest point of the hose
and to put a small container below it.
(See picture, point B).
1
A
1
Pull the ring nut A from the vent outlet at the rear.
2
Screw on the ring nut to the hose and push it into position.
3
The not used vents must be sealed with supplied covers.

DOOR REVERSAL

To make it easier to load or unload the laundry, the
door can be reversed.
WARNING! The door must only be
reversed by an authorised service
engineer.
Please contact your Authorised Service Centre.
The engineer will carry out the door reversal at your
cost.
6
2
A
There are 3 vent outlets: on the left,
right side and at the rear.

SPECIAL ACCESSORIES

stack kit
Available from your Authorised
Service Centre or your specialist
dealer
To enable the mounting of the dyer on top of a
front loading washing machine with cover's
depth between 48 and 60 cm.
Read carefully the instructions supplied with the
kit.
B

Advertisement

Table of Contents
loading

Table of Contents