Cleaning The Control Panel And Housing; Troubleshooting - Zanussi ZTE7101PZ User Manual

CAUTION! Do not use abrasive
materials or steel wool to clean the
drum.
CLEANING THE CONTROL PANEL AND
HOUSING
Use a standard neutral soap detergent to clean the
control panel and housing.

TROUBLESHOOTING

You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The display shows a long programme duration.
The display shows a short programme duration.
The display shows Err
The display shows (e.g. E51)
1) After maximum 5 hours, the programme ends automatically
2) only dryers with the display.
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• There was too much laundry in the appliance.
Problem
2)
.
2)
.
Use a moist cloth to clean. Dry the cleaned
surfaces with a soft cloth.
CAUTION! Do not use furniture
cleaning agents or cleaning agents
which can cause corrosion.
Possible solution
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
Make sure that the weight of the laundry is appli-
1)
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Make sure that the room temperature is not too
warm.
Set the Time Drying or the Extra Dry programme.
If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are applicable to the
programme.
Deactivate and activate the appliance. Start a
new programme. If the problem occurs again,
contact the Service.
• The drum is dirty.
• Incorrect setting of the conductivity sensor.
• The airflow slots are clogged.
13