Ii. Connecting With The Pc; Mass Storage Mode - Medion E4245 Operating Instructions Manual

II. Connecting with the PC

1. Press the On/Off button to start your navigation system.
2. Connect the USB cable to your navigation system.
3. Push the USB connector into a free USB port on your computer.
4. The following screen will appear after the navigation system has been connected:
mass storage
mode
Note
The ActivSync® Mode will be loaded automatically after a few seconds if no
mode has been selected.
5. Select the required mode:

Mass Storage Mode

You will be able to use your navigation software as a removable disk (as a USB stick, for exam-
ple) in the Mass Storage Mode. Two drives will be connected to do this: the internal memory of
the navigation system itself and the (optional) memory card, provided that it has been inserted
into the device.
Note
No additional entries can be made on the device at the same time, if you
are in this Mode. Use the 'Remove hardware safely' function of your oper-
ating system to protect yourself against the loss of data. Then detach the
cable from your navigation system.
The Hardware Installation Assistant will now recognize a new device and will install a suit-
able driver. This can take several minutes.
Appendix
ActiveSync
mode
65