Report Downloading; Test Unit Configuration; Software Updating - ABB SACE PR010/T Instructions Manual

To open one of the sub-menus from the main menu, simply position the cursor at
the required menu using the
ò or ñ arrow keys and press "Enter".
To return to the main menu, simply press "ESC".
The moving sequence indicates that the test unit is busy, which means you
must wait until it has finished.
Sub-menu 1. "Operation mode" is different for each type of protection unit (see
"Operation mode menu tree").
Sub-menus 2. "Report download", 3. "PR010/T Config." and 4, "SW test updating"
are instead the same for all the protection units.

5.1.1. Report downloading

The SACE PR010/T test unit can download a test report onto a PC which contains
all the information indicated under the heading "Test report".

5.1.2. Test unit configuration

The test unit's configuration can be customized.
You can define a password (Define password) to use to access the testing and
programming stages, to adjust brightness and contrast, and to select the language
of your choice (default password: 00000).
If, after specifying a new password, you want to restore the default setting, you
need to zero the password; to do so, select the "Reset password" item and notify
ABB SACE of the code displayed (e.g. CODE = 63795).
ABB SACE will provide an unlock code to input on the same page (PLEASE INSERT
RESET CODE -----), which enables you to reset the PR010/T with the default
password (00000).
N.B. The unlock code can only be used for one password zeroing operation; for
any subsequent password zeroing operations, you must go to the "Reset password"
page again and notify ABB SACE of the new code it displays (e.g. CODE = 83922)
in order to obtain the new unlock code.
You can also perform a test on the unit by selecting the "Test" menu.
The software is self-explanatory; simply follow the instructions that appear on
screen.

5.1.3. Software updating

The software installed on the SACE PR010/T test unit may be upgraded simply by
connecting it to a PC and following the procedure described below in the section
"Communication with PC".
RH0025.002
ABB SACE
SACE PR010/T L0876 12/22