Robomow Tuscania 200 Manual page 64

2.2.2 Time And Date
Allows setting time and date (figure 2.4):
EN
2.2.3 Rain Sensor
The Rain sensor feature enables the mower to detect rain and skip or stop the operation as it
is detected. There are two options under the 'Rain sensor' menu, as shown in Figure 2.5:
Set sensitivity – Enables to set the sensitivity of the rain sensor in which the mower will detect
rain below the threshold set. The default sensitivity set in the factory is 25, it means that in any
reading below 25 the mower will detect rain and will not operate. The number in the brackets
shows the actual reading of the rain sensor.
Rain sensor on/off - Allows turning the rain sensor feature off to enable operation in rain and
wet grass conditions.
2.2.4 Language
Allows the user the option of viewing the LCD text in several different language versions.
2.2.5 ECO Mode
The ECO (Economic) mode feature enables operating Robomow using minimum
energy required to cut the grass and maintain the lawn. The ECO mode default is set
to 'off'. Operation in ECO mode reduces Robomow noise level during operation and
allows longer operation time. It is recommended to use the ECO mode only in zones
with Base Station, where mowing is more frequent and a shorter part of the grass is
cut. If Robomow detects high grass it will automatically increase the power of the
mowing motor to enable cutting higher grass
2.2.6 Signal Type
In some circumstances there may be interference to the wire signal caused by other wire
signal activated in adjacent lawn (neighbor that use robotic lawnmower) or by any other
appliance using similar frequency. In case of signal interference, you may see one of the
following symptoms (usually close to the neighbor lawn):
a.
b.
c.
d.
If your mower faced one of the above symptoms, to change the signal type call to service
Figure 2.4
Time and date
Rain sensor Rain sensor Rain sensor
Press GO Press GO Press GO
Figure 2.5
Rain sensor menu
Eco mode
Eco mode
Press GO
Robomow is widely swinging when driving along the wire;
Robomow changes direction without reaching the wire;
Robomow crosses the wire outside the designated area;
'Start inside' message is displayed although Robomow is inside the esignated area and
the perimeter wire is connected in the right polarity;
Time and date Time and date Time and date
Press GO Press GO Press GO
Scroll UP/DOWN to set the Scroll UP/DOWN to set the
00:00 dd/mm/yy 00:00 dd/mm/yy 00:00 dd/mm/yy
clock and the date and clock and the date and
Next digit Next digit Next digit
press 'GO' for the next digit press 'GO' for the next digit
10:37 23/04/07 10:37 23/04/07 10:37 23/04/07
Press 'GO' to confirm Press 'GO' to confirm
Confirm Confirm Confirm
Set sensitivity Set sensitivity
Press GO Press GO
Rain sensor Rain sensor Rain sensor on on on
Press GO Press GO Press GO
.
off
off Eco mode
Press GO
22
Press 'GO' Press 'GO'
Reading (29) 25 Reading (29) 25 Reading (29) 25 Reading (29) 25
Confirm Confirm Confirm Confirm
Rain sensor Rain sensor Rain sensor off off off
Confirm Confirm Confirm
on
on
Confirm