Electrical Installation - Iec; Contents Of This Chapter; Warnings; Required Tools - ABB ACS380 Hardware Manual

Electrical installation – IEC

Contents of this chapter

This chapter describes how to:
• measure the insulation
• do the grounding system compatibility check
• change the EMC filter or ground-to-phase varistor connection
• connect the power and control cables
• install optional modules
• connect a PC.

Warnings

WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur. If you are not a qualified electrical
professional, do not do installation or maintenance work.

Required tools

To do the electrical installation, you need the following tools:
• wire stripper
• screwdriver or wrench with a set of suitable bits. For motor cable terminals, the
recommended screwdriver shaft length is 150 mm (5.9 in).
Electrical installation – IEC 65
6