HIKVISION DS-K2600 Series Manual

DS-K2600 Series Controller Connect to Wiegand Reader
DS-K2600 Series Controller Connect To Wiegand Reader
Operation Process
1) Set reader dip switch as wiegand mode.
2) Connect DS-K2600 controller to RS485 reader
3) Check reader LED status
Operation Steps:
1. Set reader dip switch as wiegand mode.
a) The former 4 dip switch are used to configure RS485 address, so in wiegand mode set them as OFF.
th
b) Set 6 dip switch as ON, the 7
2. Connect DS-K2600 to wiegand reader
a) There are 4 ports on the top.
In model K2604, reader1 for door1 entrance, reader2 for door2 entrance, etc.
In model K2602, reader 1 for door1 entrance, reader 2 for door1 exit, 3 for door2 entrance, 4 for door2
exit.
b) Connect red cable to +12V, normally only connect +12V, GND, W0, W1 four cables is enough, if want to
control LED light or buzzer of the reader, please also connect BZ/ERR/OK
th
dip switch is for wiegand 26 only, default set as OFF(wiegand34 mode).