HIKVISION DS-K2600 Series Manual

DS-K2600 Series Controller Connect to RS485 Reader
DS-K2600 Series Controller Connect To RS485 Reader
Operation Process
1) Set reader dip switch for RS485 address.
2) Connect DS-K2600 controller to RS485 reader
3) Check reader LED status
Operation Steps:
1. Set dip switch for RS485 reader.
a) The former 4 dip switch are used to configure RS485 address, address 1 for door 1 entrance, 2 for door1
exit, 3 for door2 entrance, 4 for door2 exit, etc. maximum address 8 for door4 exit.
b) When reader works in RS485 mode, the latter 4 dip switch set as OFF status
DIP Switch status
1000 0000
0100 0000
1100 0000
0010 0000
1010 0000
0110 0000
1110 0000
0001 0000
2. Connect DS-K2600 to RS485 reader
3. Check reader LED status
If connect correct, the LED light on reader should blink in blue color, if in red color it means communication
error happens, please check the wiring or dip switch.
Access point Card reader
Entrance reader 1
Door1
Exit reader 2
Entrance reader 3
Door2
Exit reader 4
Entrance reader 5
Door3
Exit reader 6
Entrance reader 7
Door4
Exit reader 8