Coway Airmega AP-1220B Instructions Manual page 13

Buttons
1 Power 2
button
1 Power Button
Use the button to turn the product on
and off.
∗ When you operate the product for the first
time, it is operated in Auto Mode. If you turn
off the product during operation and turn it
on again, it is operated in the mode active
before the product was turned off.
3 Air Volume Button
Press the Air Volume button to select the
air volume, which is switched in the order
of 1 → 2 → 3.
Mood/Lock Button
5
Use the button to turn the pollution level
indicator and other indicators on and off. While
the pollution level indicator and other indicators
are turned on, pressing the Mood/Lock button
repeatedly executes the following: pollution level
indicator OFF → all other indicators OFF → all
indicators ON.
∗ You can lock all the buttons by pressing and
holding this button for more than 2 seconds. Press
the button again for more than 2 seconds to unlock
the buttons.
∗ If you press this button while the buttons are
locked, a sound informs you of the locked status.
Mode 3 Air Volume
button button
4 Filter Replacement 5 Mood/Lock
Cycle button button
6 Multi-action lever
2 Mode Button
Press the Mode button to switch between
Auto → Silent → Turbo Modes.
4 Filter Replacement Cycle Button
If the filter alarm indicator is on, clean or
replace the filter and press the button
for two seconds or longer to reset the
replacement cycle.
∗ If the PRE and HEPA/CARBON lights are turned
on at the same time, they reset together.
∗ If the filter alarm indicator is not turned on, this
button does not operate.
∗ If you have replaced or repaired the filter before
the filter alarm indicator was turned on, refer to
page 15.
Multi-action lever
6
Turn the lever to select the circulation mode.
Rotate the lever's indicator 90 degrees forward
or upward.
- Turn indicator upward: NORMAL Mode, upward
discharge
- Turn indicator forward: FOCUS Mode, forward
discharge
11
12