Page 4
ARts iAgRAM 5.3 v ................21 ACUUM sseMbLy ARts iAgRAM 5.4 v ................21 ACUUM sseMbLy ARts iAgRAM kaivac 5.5 A .................. 22 sseMbLy ARts iAgRAM 5.6 Q ..............22 UiCk hAnge oWeR sseMbLy iAgRAM cleaning systems Customer/Technical Support P a g e ǀ...
AUTOVAC STRETCH 1.2 W ARRAnty egistRAtion Thank you for purchasing a Kaivac product. Please take a few moments to register your product at kaivac.com/warranty. kaivac Why register? • Ensure your warranty coverage • Simplify warranty service in the future with your information on file •...
• Under no circumstances will Kaivac be liable for any loss, damage, expenses or consequential damages arising in connection with the use or inability to use Kaivac’s product. This warranty is in lieu of any other warranty kaivac expressed or implied, including any warranty of merchantability or fitness for a particular purpose.
Stay alert - watch what you are doing. • Keep operating area clear of all persons. • The Kaivac shall be disconnected from mains during cleaning or maintenance and when replacing parts or converting the machine to another function. • Turn off all controls before unplugging.
Page 8
SPRAY SYSTEM WARNINGS (ONLY): • Do not spray liquid from the Kaivac onto electrical outlets or any electrical devices. • Risk of injection or injury to persons - do not direct discharge stream at persons. • INJECTION HAZARD: Equipment can cause serious injury if the spray permeates the skin. do not point the gun at anyone or any part of the body.
Page 9
DO NOT charge batteries outdoors. • DO NOT attempt to repair, service or modify the batteries or charger. Contact Kaivac Technical Support with any issues. • DO NOT short-circuit the battery or charger terminals with conductive items such as paper clips. This can deliver high current, resulting in heat and fire.
Page 10
DO NOT use without Vacuum Motor Float Cage in place. SPRAY SYSTEM WARNINGS (ONLY): • Do not spray liquid from the Kaivac onto electrical outlets or any electrical devices. • Risk of injection or injury to persons - do not direct discharge stream at persons.
Page 11
Fully Discharge vs. Partial Discharge and the Effect on Battery Cycles: Unlike lead acid batteries typically used in auto scrubber, the Kaivac Battery is not damaged by fully discharging. The BMS (Battery Management System) has a cutoff voltage of 30V which protects the Battery from experi- encing full discharge.
Page 12
Push key IN and rotate counter Key needs to be in Once in place, turn key clockwise to OFF to lock in place. clockwise to Unlock. unlock position to remove 2.2 p epLACeMent kaivac cleaning systems Customer/Technical Support 1-800-287-1136...
Page 13
CAUTION: Before filling with solution, ensure the spigot is in the “OFF” position. Fill the tank with Kaivac or Kaivac approved Chemicals. Follow the proper dilution instructions on bottles or dispenser. For accuracy and conve- nience, use Kaivac proportioned chemical packets. Do not add chemical to Trolley-Bucket if using Pump Box set-up.
3.3 A peRAtion The AutoVac feature is a walk-behind system for high speed cleaning of hard surface areas. It cleans as well and as fast as a walk-behind or ride-on auto scrubber at a fraction of the cost. After the unit has been filled with the appropriate amount of water/solution, ensure that the AutoVac Connector on the side of the cart is connected in place.
Page 15
To make use of the Stretch process: After you have fully emptied the trolley bucket of solution, you can then reuse the recovered solution to extend (or STRETCH) the AutoVac process by turning the handle mounted on the Vacuum Tank to the right (as displayed below) and dispensing the recovered solution back into the Trolley Bucket.
Page 16
Rinse Vacuum Tank thoroughly at clean-up sink, preferably with hot water. Remove debris from float ball and wire mesh Float Cage housing with hot water. Scrub debris from Spreader Pad with broom. kaivac cleaning Sweep debris. Vacuum if necessary. systems Customer/Technical Support P a g e ǀ...
Page 18
MAGNETIC SWITCH 36VDC Thumb-Lock Plug VACUUM Red + Black - MOTOR Black + CHARGE IND. Red + Orange + kaivac BATTERY PACK 36 VDC Red + Black - cleaning Red + Black - systems 36VDC Thumb-Lock Receptacle Customer/Technical Support P a g e ǀ...
Page 22
SPREADER PLASTIC ARM BLACK CSS191 #12-24 X 5/8 SCREW FOR ARM CSS102 ACORN NUT FOR ARM AVVP AUTOVAC VAC PLOW SUBSSSAL AUTOVAC ASSEMBLY SNAP & STRAP LONG CSS191 #12-24 X 5/8 SCREW FOR ARM 5.6 Q UiCk hAnge oWeR sseMbLy...
Need help?
Do you have a question about the AUTOVAC and is the answer not in the manual?
Questions and answers