Table of Contents
Advertisement
2
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately that all
parts and accessories are included.
ITEM DESCRIPTION
A
Folded Miter Saw Stand
B
Quick Release Mounting Brackets
2
C
Wheel Brackets (Left and Right)
D
Wheels
E
Bolts (wheel)
F
Lock nuts (wheel)
G
Roller Bars
H
Wheel Bushings
I
Locking Knobs
J
Saw Mounting Hardware
M6 X 60 Mounting Bolt, Washer, Lock
Washers and Nut
NOTE: This hardware is used to attach
the miter saw directly to the quick release
mounting brackets.
M6 X 27 Mounting Bolt, Washer, Lock
Washers and Nut
NOTE: Some miter saws will not fit the quick
connect release bracket exactly. These saws
need to be mounted to a plywood base before
attaching the quick release brackets. Use this
hardware to mount the saw to a plywood base
and then use the M6 x 60 mounting hardware
set to mount the saw/plywood base to the
quick release mounting brackets.
Figure 1
A
B
C
D
WARNING
Do not use the miter saw stand until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with this miter saw stand.
ASSEMBLY
I
G
E
H
J
F
WARNING
Do not use the miter saw stand for scaffolding or as
a ladder. Make sure to securely tighten all fasteners
before using. Maximum capacity is 440 Ibs (200 kg).
QTY
IMPORTANT: Maximum capacity is 440 Ibs (200 kg) with
1
the stand locked in the highest position (32-3/8") or 330
2
lbs (150 kg) with the stand locked in the medium position
2
(26-7/16"). Power tools on the miter saw stand should not
2
exceed a combined overall height of 60" (152.4 cm) from
2
the floor.
2
2
TOOLS NEEDED
4
The following tools (not included) are needed to assemble
4
the miter saw stand:
4
1 - 12 mm open end wrench or adjustable wrench
1 - 19 mm open end wrench or adjustable wrench
ASSEMBLE WHEELS
Refer to Figure 2, 3
4
• Push wheel bushings into each side of the wheel hub.
• Slide the wheel bracket over the wheel/bushings.
NOTE: There is a LEFT and RIGHT wheel bracket. The
LEFT and RIGHT brackets are determined by the pin
welded on the side of each bracket; the pin is located
on the right side of the LEFT bracket and the left side of
the RIGHT bracket.
• Place the wheel bracket pin into the hole located on the
outside of the leg.
• Slide the bolt through the wheel bracket, wheel/
bushings and frame.
• Assemble locknut and tighten with a 19 mm or
adjustable wrench.
• Repeat to assemble the other wheel.
Figure 2
Left Wheel Bracket
Wheel
Bushings
Lock and Unlock Wheels
Both wheels are equipped with a locking mechanism to
lock and unlock the wheels:
• Depress the side of the wheel bracket with the lock
symbol to lock the wheel.
Welded Pin
Frame
Bolt
Lock
Nut
Advertisement
Table of Contents
