Unique CLASSIC RETRO UGP-30CR RH W Owner's Manual
Hide thumbs
Also See for CLASSIC RETRO UGP-30CR RH W:
- Owner's manual (52 pages) ,
- Owner's manual (33 pages)
Related Manuals for Unique CLASSIC RETRO UGP-30CR RH W
Summary of Contents for Unique CLASSIC RETRO UGP-30CR RH W
- Page 1 CLASSIC RETRO BY UNIQUE 30” RANGE HOOD MODEL NUMBERS: UGP-30CR RH W, UGP-30CR RH T, UGP-30CR RH LG, UGP-30CR RH RB OWNER’S GUIDE serial number: DEC20V1...
-
Page 2: Table Of Contents
TABLE OF CONTENTS SAFETY NOTICE PRE INSTALLATION NECESSARY TOOLS PARTS INCLUDED PARTS LIST INSTALLATION PROCEDURE OPERATING INSTRUCTIONS TROUBLESHOOTING MAINTENANCE TECHNICAL SPECIFICATIONS WIRING DIAGRAM PARTS DIAGRAM AND LIST WARRANTY APPLIANCE INFORMATION NOTES PRODUCT REGISTRATION CONTACT US... -
Page 3: Safety Notice
SAFETY NOTICES Approved for residential type units for residential use only read these instructions and be safe. Please read these instructions completely before starting. The installation of the appliance must respect all codes. Important: Save these instruction so that you can provide the electrical inspector in your area. - Page 4 SAFETY NOTICES To reduce the risk of fire and to properly exhaust air, be sure that the pipe is leading outside, do not exhaust air into the space between the walls, ceilings, attics, crawl spaces or garages. WARNING — GROUNDING INSTRUCTIONS This device must be grounded.
- Page 5 SAFETY NOTICES WARNING — TO AVOID INJURING SOMEONE IN A GREASE FIRE, FOLLOW THE FOLLOWING: 1. SMOTHER FLAMES with a lid to the dimensions of the cooking hobs, a cookie sheet or other metal tray, then turn off the gas or power supply of the stove.
-
Page 6: Pre Installation
PRE INSTALLATION CAUTION Due to the weight and size of these vent hoods and to reduce the risk of personal injury or damage to the product, TWO, TO THREE PEOPLE ARE REQUIRED FOR PROPER INSTALLATION. • Please read the instructions carefully. Unpack the range hood and check that all functions are working before installing. - Page 7 PRE INSTALLATION 750 mm (29.5”) MEASUREMENTS Front View Top View 755 mm (29.75”) 755 mm (29.75”) 750 mm (29.5”) 680 mm (26.75”) 305 mm (12”) 723 mm (28.5”) 750 mm (29.5”) 558.8 mm (22”) 755 mm (29.75”) 750 mm (29.5”) 3/4 View Side View 680 mm (26.75”)
-
Page 8: Necessary Tools
PRE INSTALLATION DUCT PLANNING • The ventilation hood is equipped for 8” round ducts. This hood can be ventilated vertically through the top cabinet or ceiling. A duct transition piece is provided for vertical exhaust. You can use elbows (sold separately) to ventilate horizontally through the rear wall. •... -
Page 9: Parts Included
PARTS INCLUDED PARTS LIST A) Metal anchors (concrete installations) - 4 pcs B) Damper Flap - 1 (could be attached to range hood) C) Plastic Anchors (drywall installations)- 10 pcs D) ST4*4 x 35 mm wood screws - 10 pcs E) ST4*4 x 12 mm metal screws - 6 pcs (use only if not installing into the top cabinets) F) Metal Hinges - 2 pcs... -
Page 10: Installation Procedure
INSTALLATION PROCEDURES Caution: The range hood has sharp edges Please wear protective work gloves to remove parts, installation, cleaning and servicing. Step 1: • Connect the Duct into the Damper. • Secure the Duct around the Damper with the Duct Clamp. Important: For best results, the mounting height of range hood should be 65 - 75 cm (24”... - Page 11 INSTALLATION PROCEDURES MIN. 24” MAX. 36” CEILING HEIGHT 36” Step 2: Caution: When installing the hood, the height should not be too high or too low. Before the installation, please inspect the maximum height of your ceiling and bonnet. Too high, will affect the efficiency of the hood;...
- Page 12 INSTALLATION PROCEDURE Top and rear mount (USE HINGES ONLY IF NOT INSTALLING installation UPPER SCREWS INTO THE TOP CABINETS) Due to the weight of the unit, it is recommended to mount the hood at the bottom of the upper cabinet and then fi x it to the wall to avoid gaps.
- Page 13 INSTALLATION PROCEDURE TIGHTEN TOP FIRST TIGHTEN TO WALL SECOND THESE STEPS REQUIRE LIFTING AND HANGING AT THE SAME TIME - USE TWO/THREE PEOPLE 6. Locate the top (cabinet) holes and line up hood holes, while also lining up to holes with the protruding wall screws. 7.
- Page 14 INSTALLATION PROCEDURE Metal Filter Installation 1. Install the Drip Tray inside the bottom rear of the range hood. (Fig 1) 2. Install the filters by inserting at an angle towards the rear of the range hood. (Fig 2) 3. Push the filter up and insert front of filter into front recess. (Fig 3) 4.
-
Page 15: Operating Instructions
OPERATING INSTRUCTIONS Touch Controls Function Buttons: LOW SPEED Fan Buttons: Power on by pressing MEDIUM SPEED any button of F2/F3/F4, fan starts and F5 light automatically but does HIGH SPEED not blink. LED LIGHT TROUBLESHOOTING PROBLEM CAUSE SOLUTION After Installation, motor and The power is not on Make sure the circuit breaker and the lights are not working. -
Page 16: Maintenance
MAINTENANCE CAUTION: NEVER PUT YOUR HANDS INSIDE THE RANGE HOOD WHILE IT IS IN OPERATION. CLEANING For best performance, clean the range hood regularly. 1. Use only mild soap or cleaning solutions to clean the exterior surface of the range hood. Use a soft cloth to dry the surface. 2. -
Page 17: Technical Specifications
TECHNICAL SPECIFICATIONS MODEL UGP-30 CR RH 30” (76.2 cm) SIZE 700 CFM RATED POWER 3 speed power control CONTROLS Below 65 dbA NOISE LEVEL 1.5W LED Lamps x 2 LIGHTS Dishwasher safe stainless steel baffle filters CLEANING 10” H x 29.5” W x 22” D DIMENSIONS WEIGHT (UNBOXED) 56 lbs / 25 kg 110V, 60Hz... -
Page 18: Parts Diagram And List
PARTS DIAGRAM AND LIST... - Page 19 PARTS DIAGRAM AND LIST Item # Part Number Description Classic Retro Logo Unique Classic Logo UGP-SNG01 Coloured Range Hood Body ASSY (not for individual sale) for UGP-30CR RH UGP-SNG02 Wall Mounting Bracket for UGP-30CR RH UGP-SNG03 Motor Housing ASSY (not for individual sale) for UGP-30CR RH...
-
Page 20: Warranty
This Warranty is made only to the first purchaser (”original purchaser”) who acquires this range hood for his/her own use and will be honored by Unique Appliances and by the Seller. Purchaser must retain their receipt as proof of purchase date. - Page 21 Nothing within this warranty shall imply that Unique will be responsible or liable for any direct or indirect loss of foods caused by failure in operation.
-
Page 22: Appliance Information
APPLIANCE INFORMATION (manual copy - keep with your records) Please record the following information for future reference: Model: Serial Number: Purchased From: Date Purchased: NOTES PRODUCT REGISTRATION Please visit our website at https://UniqueAppliances.com/product-registration/ to register your product. -
Page 23: Contact Us
Email info@UniqueAppliances.com Toll-free 1-877-427-2266 or 1-905-827-6154 available during regular business hours, 8:30 am to 4:30 pm, EST Website www.UniqueAppliances.com Please visit our website for more quality Unique products: www.UniqueAppliances.com... - Page 24 © 2020 Unique Appliances Ltd., 2245 Wyecroft Road, Oakville, Ontario, Canada, L6L 5L7 www.uniqueappliances.com...
Need help?
Do you have a question about the CLASSIC RETRO UGP-30CR RH W and is the answer not in the manual?
Questions and answers
Can this be vented out the back