Rightline Gear campright Setup Manual

Truck Tent Set Up Guide
1-With the tailgate down, place the tent in your truck
bed with screen mesh side facing up. Slip the tailgate
pocket and under-strap over the end of the tailgate.
(Fig 1).
2-Attach the black strap clips to the bottom outside lip
of the truck and snug up the straps. (Fig 2).
3-Run all 4 tent poles through their matching color
coded sleeves. Raise the two gray center poles first
followed by the green and red poles. Insert the pole
ends into their matching color coded pockets. Make
sure the pole sleeves slide over the poles with no hang-
ups -don't force the poles. (Fig 3).
Fig 1
Fig 3
4-Attach the inside green and red straps to your truck
bed corner tie down points/cleats. Notice two straps
clip to each cleat. If your truck does not have tie down
points, clip the two front red straps together (Fig 4)
and run the two back green straps through the tail-
gate gap to attach to something below (Fig 5). With
this option, the middle two red and green straps will
hang free. Once you have the straps adjusted for your
truck, the next set-up will be much easier.
Fig 4
Fig 2
Fig 5
Visit: www.rightlinegear.com
5-Adjust the inner and outer straps until the seam
where the inner flap meets the tent runs along the top
outside edge of your truck bed. (Fig 6).
6-Position the rain fly over the tent. Place the front cab
access sleeve from the tent inside the access sleeve of
the rain fly. Attach the buckles and adjust their straps
as necessary. (Fig 7). Use of the rain fly is optional.
CAUTION: Do not drive with the tent set up. Do not
run the truck engine when anyone is inside the tent.
Please read and observe the caution tag inside of
the tent.
Avalanche Truck Tents: Set up is exactly the same ex-
cept that it is necessary for you to run the stitched front
edge of the tent (has 2 tie down strings sewn inside)
in the opening between the plastic rear window frame
and the metal roof. All three black strap clips from this
area will attach in a row to the bottom outside lip of
the truck. (Fig 8). The front most black clips from the
rainfly should be secured inside the vehicle on the front
cleats. (Fig 9). CAUTION: Metal magnets are located
inside the front of the rain fly to hold it in place. Be
careful when placing on the roof of your Avalanche.
Fig 8
Fig 6
Fig 7
Fig 9