Rightline Gear 100S30 Quick Start Manual

Sport Car Top Carriers
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.

Pack The Carrier

WARNING: DAMAGE MAY OCCUR TO THE CARRIER
IF EXCESS MATERIAL FLAPS IN THE WIND.
TO ELIMINATE EXCESS MATERIAL, PACK THE CARRIER
FULL. IF UNABLE TO PACK FULL, FILL THE ENCLOSED
SPACE OF THE CARRIER AND PULL THE EXCESS
MATERIAL DOWN OVER THE SIDES. HOLD THE EXCESS
MATERIAL SECURELY IN PLACE WITH THE CARRIER'S
STRAPS.
1-Apply a small amount of the included lubricant to the
outer surface of the zipper (Fig 1). Run the zipper head
over the lubricant and around the carrier several times to
ensure proper lubrication.
Fig 1
NOTE: THE LUBRICANT HELPS THE ZIPPER HEADS
EASILY SLIDE OVER THE OUTER RUBBER SURFACE
OF THE ZIPPER. PETROLEUM JELLY, WD-40, AND LIP
BALM CAN BE USED AS ALTERNATIVES. DO NOT
APPLY THE LUBRICANT ON THE ZIPPER TEETH.
2-Clean the vehicle's roof of all dirt and debris.
3-Unzip the carrier completely and place it on top of the
vehicle with its non-zippered end facing front.
4-Start by completely filling the enclosed space in the front
part of the carrier with your gear (Fig 2). Continue loading
the rear of the carrier. Place sharp edged items in the
middle and softer items around them.
5-Close the zipper as you fill the carrier. Bring the (2) zip-
per heads together under the rear protector and secure
the hook-&-loop closure (Fig 3).
100S30, 100S20, 100S50
Enclosed Space
Zipper
End
Hook-&-Loop
Closures
Fig 2
WARNING: FOR THE CARRIER TO BE 100% WATER-
PROOF, THE NON-ZIPPERED END MUST BE FACING
THE FRONT OF THE VEHICLE, THE (2) ZIPPER HEADS
MUST BE LOCATED IN THE CENTER OF THE REAR
PROTECTOR, AND THE HOOK-&-LOOP CLOSURE ON
THE PROTECTOR MUST BE SECURED.

Attach The Carrier - WITH A Roof Rack

NOTE: REQUIRES SPACE UNDER THE ROOF RACK
SIDE RAILS OR CROSS BARS FOR THE CARRIER'S
ATTACHMENT STRAPS TO PASS THROUGH.
1-Remove the Car Clips from the (4) attachment straps (Fig
4); the Car Clips will not be used.
Fig 4
2-Decide if you will be attaching the straps to the roof
rack side rails or cross bars. If side rails, the straps will
connect to the side buckles (Fig 5). If cross bars, the straps
will connect to the front and rear buckles (Fig 5).
Cross
Bar
Front
Front
Buckles
Fig 5
3-Attach each strap by wrapping it around the rack,
threading its end through its loop, and pulling tight (Fig 6).
4-Thread the straps up through slot A and down through
slot B of the buckles (Fig 7) and tighten the straps evenly.
5-Tie off the strap ends so they don't flap in the wind (Fig
8). Make sure to re-tighten the straps after a few miles
and check them regularly throughout the trip.
Rear
Protector
Hook-&-Loop
Fig 3 Closures
Side Rail
Cross
Side
Rear
Buckles
Buckles
Side Rail
Bar