Rightline Gear 100J72-B Manual

Trunk Storage Bag
Fits: Wrangler JK (2-door & 4-door)
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Pack The Trunk Storage Bag
1-Slide the hard plastic insert into the top sleeve (Fig 1).
2-Secure the (2) hard plastic shelves onto the horizontal
dividers with the hook-&-loop fasteners (Fig 2).
Fig 1
3-Place items like recovery gear, clothing, towels, grocer-
ies, first aid kits, road side equipment, snacks, etc. in the (4)
main compartments. Place smaller items in the inner mesh
pouch (Fig 3).
4-Close the zippers and secure the hook-&-loop closures
at the bottom of each compartment (Fig 4).
Fig 3
Attach The Trunk Storage Bag
Wrangler JK (2-door)
1-Position the bag behind the rear seat. The top of the
bag should follow a straight line parallel to the top of the
rear seat (Fig 5).
A
Fig 5
100J72-B
Fig 2
Fig 4
B C
D
2-Buckle (2) of the rear side straps through their matching
attachment rings on the bottom of the rear seat (Fig 6).
Rear Side
Of Bag
Fig 6
3-Buckle the A strap around the left rear vertical roll bar,
above the seat belt holder, without twisting the strap (Fig
5 and Fig 7).
4-Buckle the D strap around the right rear vertical roll bar,
above the seat belt holder, without twisting the strap (Fig
5 and Fig 8).
Fig 7
5-Buckle the B strap around the left headrest, without
twisting the strap (Fig 5 and Fig 9).
6-Buckle the C strap around the right headrest, without
twisting the strap (Fig 5 and Fig 10).
Fig 9
7-Tighten all (4) straps. The top of the bag should follow
a straight line parallel to the top of the rear seat (Fig
11).
Fig 11
CAUTION: Make sure that the rear seat belts can move
unrestricted before operating the vehicle.
Attachment
Ring
Rear Side
Strap
Fig 8
Fig 10