Description; Product Overview; Feature Description; Intended Use - Dräger FPS 7000 Instructions For Use Manual

en

Description

3 Description
3.1

Product overview

(see figure A1 and A2 on page 3)
1 Visor frame, top
3 Sliding buckle
5 Facepiece body
7 Cap
9 Nose cup valve
11 Visor
13 Speech diaphragm
15 Spring bridge with spring and
spring guide
17 Inhalation valve and
inhalation valve seat
19 Clamping ring
21 Funnel
3.2

Feature description

The facepieces of the Dräger FPS 7000 series are part of NIOSH
approved respirators and protect the face and the eyes against
aggressive substances.
The facepieces may be used at temperatures from -22 °F to +140 °F
(-30 °C to +60 °C). Lower or higher temperatures are permitted when
the exposure time is short.
6
2 Hairnet
4 Neck strap
6 Flap
8 Visor frame, bottom
10 Nose cup
12 P18-type connector
14 Exhalation valve seat
16 Exhalation valve disk
18 Screw
20 O-ring
3.3

Intended use

The facepieces may only be used with approved Dräger self-contained
breathing apparatus (see approval label of the respective breathing
apparatus). Otherwise the correct functioning of the device may be
compromised.
3.4

Limitations on use

Correct fit of the facepiece can only be achieved if the complete
facepiece seal makes contact with skin. Head hair, facial hair
(including beard stubble and sideburns), earrings, other facial
piercings and normal eyeglasses will interfere with the facepiece seal
and are not permitted in the sealing area. Use the special spectacle kit
FPS 7000. Additionally, head hair that could affect the facepiece fit
(buns, high pony-tails, hairpieces, etc.) is not permitted!
3.5 Explanation of type-identifying marking and
symbols
Parts of the facepieces are marked as follows:
Part Marking
Connector P18
Facepiece body EPDM
S (small), M (medium), L (large)
[size of the facepiece body]
Nose cup 1 (small), 2 (medium), 3 (large)
[size of the nose cup]