Initial Start-Up - FLORABEST FLS 3000 B2 Translation Of The Original Instructions

GB IE
Electrical safety:
• Make sure that the mains volt-
age is compatible with the infor-
mation of the label.
• Connect the device, as far as
possible, only to a plug socket
with a ground-fault circuit inter-
rupter (g.f.c.i switch), with a
rated residual current at not
more than 30 mA.
• Check the device and the pow-
er cable with plug for damage
before every use. Avoid bodily
contact with grounded parts
(e.g. metal fences, metal post).
• The coupling of the extension
cord must be protected against
splashed water, it must consist
of rubber or be surrounded by
rubber. Employ only extension
cords which are stipulated for
use in the open air and are
marked accordingly. The flex-
ible lead cross-section of the
extension cord must at least 2.5
mm . Always roll out the cable
2
drum completely before use.
Check the cable for damage.
• Keep the cable away from the
field of action and basically
play it out behind the operator.
• Use the tension relief provided for
the fixing of the extension cord.
• Do not carry the device by the
cable. Do not use the cable to
pull out the plug from the plug
socket. Protect the cable against
heat, oil and sharp edges.
• Damaged cables, coupling and
plugs or connecting leads not
corresponding to specifications,
must not be employed. Remove
the plug immediately from the
10
plug socket in case of damage
to the mains cable.
Do not touch the mains power
supply cable under any circum-
stances until you have pulled the
plug out of the mains socket.
• If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per-
son in order to prevent hazards.
• Do not use the appliance if the
on/off switch does not work
properly. Always have a dam-
aged switch repaired by our
Service Centre.
• Do not overload your device.
Work only within the indicated
range of performance. Do not
employ any low power ma-
chines for heavy work. Do not
use your device for purposes for
which it has not been designed.
• Before each use, check the pow-
er supply lead and the extension
cable for damage and ageing.
Do not use the equipment if the
cable is damaged or worn.
• After they have been joined to-
gether, the blower tubes cannot
be taken apart again!

Initial start-up

Before operating the equipment, you must
- install the blower or suction pipes,
- install the collection bag for suctioning
leaves,
- install the protective cover (suction in-
take) for blowing leaves.
Caution, Risk of Injury! Du-
ring the assembly or disas-