Table of Contents
Advertisement
• Safety Check
- Upon completion of any service or repairs to this product, ask the service technician to perform
safety checks to determine that the product is in proper operating condition.
• Handling Notice
- Only qualified service personnel should handle and install this unit. A series of screws with lock
washers are used to secure the top and bottom covers of the unit. Use caution when handling the
unit as the lock washers may have rough edges. Do NOT run your fingers over the top and bottom
covers of the unit.
• Do not block any of the ventilation openings. Install in accordance with the manufacturer's
instructions.
- The product can be deformed or fire can break out due to overheating inside the product.
• Do not place the product in a built-in installation such as bookcase or rack.
- Ventilation required.
• DISCONNECTING DEVICE FROM MAINS
- Mains plug is the disconnecting device. The plug must remain readily operable.
• Do not place anything containing liquid on top of the product such as flowerpot, cup, cosmetics or
candle.
- This may cause a fire hazard.
PCS500R Rack Installation (See p. 15, 16)
• Wear a properly grounded, antistatic wrist strap to avoid causing electrostatic (ESD) damage to the
PCS500R.
• Carefully slide the PCS500R into a standard 19-inch equipment rack.
• When mounting in the rack, make sure to use the appropriate hardware. ALL FOUR MOUNTING
SCREWS MUST BE USED.
• This equipment is not designed to support other devices. Do NOT stack other equipment on the top
of the PCS500R.
• Rear cabling must be dressed and supported so that the weight of the cabling is not a strain on the
PCS500R connectors.
• MOUNTING OF THE EQUIPMENT IN THE RACK SHOULD BE SUCH THAT A HAZARDOUS
CONDITION IS NOT ACHIEVED DUE TO UNEVEN MECHANICAL LOADING.
7
Hide quick links:
Advertisement
Table of Contents
