LG PCS500R Pro:Centric Installation & Setup Manual Warranty page 21

6 Either:
• Type and press
• Type and press
Note: Select the appropriate application based on the purchase order associated with this server. The software
license specifies the Java or HTML application, and the application type must be set accordingly in this step.
Once you make your selection, the server will display confirmation before initiating a reboot, for example:
7 When the reboot is complete, you should see a new login prompt. Log back in to the server (see step 5).
Once you are logged in, you will see a
The next step describes how to set static IP addresses for the Control Port and/or Feature Port, if desired/
applicable. The Control Port is used for remote management/communication purposes, while the Feature Port
is designated for PCS500R IP or hybrid RF/IP output. By default, both ports are configured for DHCP.
• Note: You can press
• Note: To view the server's current configuration settings, type
The System Information display will show the IP address that has been assigned to the Control Port (if the
network is configured for DHCP) and the output configuration. See "View System Information" on page 26
for further information.
• Note: If the Control Port network is configured for DHCP but the Control Port IP address is not displayed in
the System Information display (see note above), refer to "Network Setup" troubleshooting information on
page 42. If configured, the DHCP server should assign an IP address to the Control Port once the PCS500R
successfully connects to the network.
8 (Optional) Set a static IP address for the Control Port and/or Feature Port. It is highly recommended that the
Feature Port be configured with a static IP address. See also note below regarding Feature Port.
• Note: Static configuration for the Feature Port is recommended, regardless of whether you are configuring
the system for Multicast Mode or Unicast Mode, as the Feature Port IP address is embedded in every deployed
Pro:Centric application project. After a project has been deployed and any TVs/STBs (to which the project
has been deployed) complete a boot cycle, the TVs/STBs automap themselves to the Pro:Centric server
using the Feature Port IP address. If the Feature Port IP address is assigned by a DHCP server, and the DHCP
server experiences an interruption, the IP address assignment may change, and this will cause a Pro:Centric
interruption.
• Note: For detailed information on this step and additional screen samples, see "Modify Network Settings" on
pages 27 to 30.
to select the Java application.
to select the HTML application.
at any PCS500R command prompt to view current menu, if desired.
prompt.
and press at the prompt.
21