Table of Contents
Advertisement
Accessories
Pass Ethernet cable through enclosure cable
gland as shown and reassemble connector.
Inset power cable with isolated cable ends
through cable gland on enclosure.
Using power and Ethernet cables that have been
passed through cable glands on rear of enclosure,
install cables onto camera (turn on camera if
needed).
Place camera conduction plate on inside surface
of enclosure and slide the outer slide onto the
housing as shown.
Conduction Plate
Housing
Outer Slide
Connect ground cable onto housing as shown
before closing housing.
38
Pi20
Rev. B 09/2011
Advertisement
Table of Contents
