Table of Contents
Advertisement
Accessories
Secure ground cable to camera as shown (color of
cable/ring terminals used for display only).
Disassemble
Ethernet
cable
connector
by
loosening nut as shown.
Remove cable from RJ45 jack by lifting tab, note
wiring for reassembly.
Pass Ethernet cable through cable gland on rear
enclosure flange then reassemble connector.
Pass power cable end with isolated cable ends
through cable gland on rear enclosure flange.
Using Ethernet and power cables that have been
passed through cable glands on rear flange,
install cables onto camera as shown (turn camera
on if needed).
Pi20
33
Rev. B 09/2011
Advertisement
Table of Contents
