Table of Contents
Advertisement
Accessories
Place housing internal rail onto conduction plate
as shown.
Secure conduction plate to rail by installing 2x
Screws (truss), 4x curved washers (2x per screw),
and 2x flat washers. Insert each screw half a turn
past after making contact with curved washer
and slide camera forward.
Secure ground cable to camera as shown (color of
cable/ring terminals used for display only), from
camera to internal rail screw with tooth washer.
Then install supplied ground cable onto heater
board for connection to enclosure.
Disassemble
Ethernet
cable
connector
by
loosening nut as shown.
Remove cable from RJ45 jack by lifting tab, note
wiring for reassembly.
Pi20
37
Rev. B 09/2011
Advertisement
Table of Contents
