RayTek ThermoView Pi20 Operating Instructions Manual page 24

Installation
2. Click on <Properties>:
3. Under <This connection uses the following items>, select <Internet Protocol (TCP/IP)> and
click on <Properties>:
4. Activate the radio button <Use the following IP address> and make the following settings:
IP address:
Subnet mask:
Default gateway:
24
192.168.200.x
where x is an address between 1 and 255 (except 254, which is already
used by the camera by factory default)
255.255.255.0
{empty}
Rev. B 09/2011
Pi20