Advertisement
ENGLISH
CHARACTERISTICS
The main characteristics of 1133/15 universal door phone are the following:
1. Installation in 4+n (5 wires audio) systems and in 1+n (2 wires) systems with any kind of push button
panel.
2. Possibility to have traditional call on buzzer or electronic call on handset loudspeaker.
3. Electronic call adjustment or disabling by a slide switch with three positions:
•
Maximum volume.
•
Minimum volume.
•
Call disabling (this is signalled by a little red fl ag, that comes out of the door phone body).
4. Possibility to adjust the incoming speech signal volume (handset loudspeaker).
5. Possibility to adjust the outcoming speech signal volume (handset loudspeaker).
§
By default the door phone is confi gured for 4+n signals and for call on buzzer.
INSTALLATION/CONNECTION
3
3
Identify the apartment station code and the system type in use according to the number of connected wires:
5 wires for 4+n system, 2 wires for 1+n system.
Before disconnecting and disassembling the apartment station in use, note down the wires colours and the
terminal pins number to which they are connected. Warning: sometimes there are wires with same colour.
Mark them with a sign. Write these informations in this document, in the equivalences table, at page 22.
Verify also if it is an apartment station with a buzzer ringer (12 Vac) or a loudspeaker electronic ringer. The
presence of a little coil on the handset base unit indicates that it is a buzzer ringer; see fi gure 1.
§
It is not possible to install door phones programmed for electronic ringer in systems with buzzer and
vice versa. For programming procedure, refer to the following pages.
§
The door phone Ref. 1133/15 is not compatible with Urmet Domus concierge switchboards
Mod. 605.
6
ø 6 mm
Fig. 1
INSTALLATION
BESCHREIBUNG DER KLEMMEN IN ABHÄNGIGKEIT VOM ANLAGETYP
4+n-ANLAGEN (5 Drähte audio)
1
Eingehende Sprechleitung (Lautsprecher)
CA
Anruf durch Summer oder elektronischer Anruf
2
Ausgehende Sprechleitung (Mikrofon)
6
Anlage Masse
10
Zum Anschluss an Klemme 6 der Sprechanlage
9
Türöffner
1+n-ANLAGEN (2 Drähte)
1
Anschlussmasse der Anlage
CA
Nicht angeschlossen
2
Sprechleitung/Anruf/Türöffner
6
Nicht angeschlossen
10
Zum Anschluss an Klemme 1 der Sprechanlage
9
Zum Anschluss an Klemme 2 der Sprechanlage
Mit Hilfe der Äquivalenztabelle und der Anmerkungen die Kabel wiederanschließen.
4+n-ANLAGEN
Eingehende Sprechleitung (Lautsprecher)
Anruf
Ausgehende Sprechleitung (Mikrofon)
Masse
Türöffner
Zusatztaste
1+n-ANLAGEN
Masse
Sprechleitung/Anruf/Türöffner
Zusatztaste
DS1133-009
DS1133-009
Abb. 2
1
CA
2
6
10
9
G/T
T1
1
CA
2
6
10
9
G/T
T1
19
Advertisement
