Download Print this page
urmet domus 1133/15 Installation Manual

urmet domus 1133/15 Installation Manual

Universal handset
Hide thumbs Also See for 1133/15:

Advertisement

Quick Links

1133/15 Universal handset
Installation manual

Advertisement

loading

Summary of Contents for urmet domus 1133/15

  • Page 1 1133/15 Universal handset Installation manual...
  • Page 2: Important - Please Read

    1133/15 Universal handset and not third party equipment. General notes and limitations The 1133/15 Universal handset will replace 5or 2 wire handsets. It will not replace 3, 4, 6 etc wire handsets. The call volume adjustment does not work in the AC buzzer call configuration.
  • Page 3 Urmet 1133/15 CA (E) CA (R) Speech Speech Manufacturer Lock (handset to Ground (entry Call Call release entry panel to (Electronic (12V AC panel) handset) tone) Buzzer) ACET ACET- ANTENOPHONE 901 ACET- ANTENOPHONE 701 AIPHONE (poste CVK) AMPER AMPLIVOX AMPLIVOX...
  • Page 4 TUNE URMET URMET 1130 URMET 1131, 1132, 1133 VIDEX YUS PHONE B/PT TRANSIFON VEMEL VIDEX VISIDIS (OKAY) 2-Wire handsets Urmet 1133/15 Manufacturer Ground Speech/call Electronic call Call by buzzer tone ACET 702 LT TERRANEO 603 SELTI/VIDEX 525 TONNA/VIDEX URMET 1130/50/2F...
  • Page 5 How to use the above tables. Using the Videx handset as an example – 1133/5 Videx Videx Urmet 1133/15 You must make this link CA (JPA jumper in the R position) 5-Wire terminal functions 1133/15 You must Speech f rom entry panel to handset...
  • Page 6 Jumpers and settings Note – The 1133/15 Handset default settings are for 5-wire AC buzzer type handsets If you are using the 1133/15 to replace a 5-wire buzzer type handset you do not need to move any jumpers Replacing 5-Wire handsets Jumpers JP1 to JP5 must all be as shown (position 5) –...
  • Page 7 Electronic call (through the handset speaker) AC Buzzer call JPA jumper in JPA jumper in the R position the E position Electronic call (through the handset speaker) If the handset you are replacing does not have a buzzer i.e. it calls through the handset speaker, then the JPA jumper must be in position E AC Buzzer call If the handset you are replacing has an AC then the JPA jumper must be in position R...
  • Page 8 Replacing 1 + n (2-wire) handsets Jumpers JP1 to JP5 must all be as shown (position 2) – Note – The JPC jumper must always be in the + position If the 2-wire handset you are replacing has AC buzzer call then the JPA jumper must be in the R position. If the handset has electronic call the JPA jumper must be in the E position.
  • Page 9 Check the jumper between terminals 6 and 10 is in place If the original fault was no lock release for example, and after the 1133/15 Universal handset is fitted you have the same problem, then the fault lies elsewhere in the system.