Graco 25C528 Instructions - Parts Manual page 12

Installation
Siphon Siphon Kit Siphon Kit Installation Kit Installation Installation
Use this procedure to install Siphon Kit 238250. See
Models 26B630, 26B631, 238250, page
1. Remove the top plug (5) and the bottom plug
(20).
2. Replace the bottom plug (20) with the plain
bearing (50d), and tighten the bearing with a
wrench.
3. Work the PTFE o-ring (50e) onto the siphon tube
retainer (50b). Leave the retaining nut (50c)
on the siphon tube retainer, but do not tighten.
Tighten the siphon tube retainer into the top of
the agitator housing with a wrench.
4. Slide the siphon tube (50a) down through the
retaining nut (50c), siphon tube retainer (50b),
and agitator shaft (6) until the siphon tube
touches the bottom of the drum. Raise the siphon
tube approximately ¼ in. (approximately 6 mm)
so that it does not touch the bottom of the drum.
Hold the siphon tube at this height with one hand,
and tighten the retaining nut with the other hand.
(Hand-tight is enough to hold the siphon tube in
place.)
NOTICE NOTICE NOTICE
Barrel Barrel Heights Barrel Heights Vary. Heights Vary. Vary.
Loosen the retaining nut on the siphon tube
retainer before you raise the drum cover. If you do
not loosen the retaining nut, the siphon tube may
make contact with the bottom of the barrel when
you lower the drum cover onto a new barrel, which
could damage the siphon tube or the barrel.
12
33.
Figure 4 Siphon Kit, Model 238250
Return Tube
Return Return
Return Tube Kit 238884 is available as an accessory.
The kit must be ordered separately. Refer to the
sheet packed with the kit for installation instructions.
Tube Kit Kit 238884 238884 (Accessory) (Accessory)
Tube Kit 238884 (Accessory)
3A4792G