Graco 25C528 Instructions - Parts Manual page 10

Installation
Angled Angled Angled Adapter Adapter Adapter 16H294 16H294 — — — Model 16H294
only only only
If the agitator is used on a drum with an off-center
bung and the blades contact the side of the drum, the
angled adapter 16H294 must be used.
1. Thread the locking ring (28) onto the angled
adapter (27) by hand, as far as it will go.
2. Thread the angled adapter into the bung until
it bottoms out, then back it out until the widest
portion of the adapter top is pointing just to the
left of drum center.
Figure 2 Angled Adapter Just Left of Center
3. Turn down the locking ring until it contacts the
drum. Use an appropriately sized pipe wrench or
adjustable wrench to tighten the adapter until the
widest portion of the adapter top is in line with the
drum center.
10
Model 25C530 Model 25C530 25C530 Back Geared Back Back Geared Agitator Geared Agitator Models Agitator
26B619, 26B630, 26B619, 26B619, 26B630, 26B631, 26B630, 26B631, 26B632, 26B631,
26B633
26B633 26B633
See the following sections for part information:
• Models 26B618, 26B619, page 35
• Models 26B630, 26B631, 238250, page 33
• Models 26B632, 26B633, page 37
Assembling and and Positioning Positioning the
Assembling Assembling and Positioning
With an an Elevator Elevator
With With an Elevator
Mount the drum cover as described in manual
306287. The elevator must be in the down position
when you do any work on the elevator, agitator,
or drum cover assembly. Do not go under the
elevator when it is raised. Proceed to step 1 in
Installation With or Without an Elevator, page
Without an an Elevator Elevator
Without Without an Elevator
If your system does not have an elevator, install the
Handles Kit 237524 to facilitate handling the drum
cover and agitator. Two people are needed to safely
lift and move the drum cover and agitator. Place two
standard 55 U.S. gallon (45 Imperial gallon) barrels
14 in. (36 cm) apart. Center the drum cover on the
barrels with the Graco logo centered and facing you,
as shown in the following figure. Proceed to step 1 in
Installation With or Without an Elevator, page
Figure 3 Assembling and Positioning Agitator
Without an Elevator
Models 26B618, Models 26B618, 26B618,
26B632, and 26B632, and and
the Agitator Agitator
the Agitator
11.
11.
3A4792G