Due to constant efforts to improve our products, certain procedures and specifications are subject to change without notice, if you have any questions, please contact Promate Service. CONTENTS 1.
OTHER SAFETY PRECAUTIONS 1. Safety Precautions Parts become hot when the generator runs. Take care not to Please make sure you review each burn yourself. precaution carefully. The muffler and other engine parts become very hot while the engine is running or just after it has stopped.
ENGINE OIL 3. Inspection We recommend the American Petroleum Before Operation Institute (A.P.I.) classifications of CC or CD for optimum performance. Always use the oil with the right viscosity for the ambient Place the generator on a firm and flat temperature where your engine is being surface.
Overfilling is dangerous. Do not fill the tank beyond the top of the fuel filter shoulder. Make sure your unit is on a flat surface when checking the oil level. If it is tilted, the gauge will be For PM13000D ES (Silent) inaccurate.
30 seconds before trying (is it black or too white)? to start it again. *If you notice any abnormalities, discontinue use and contact your Promate Service If the engine does not start after 3 immediately. attempts, check the battery or call Promate Service.
6. Stopping Your Generator Set a. Gradually turn off connected appliances starting with lights and ending with the motorized appliances (e.g. Aircon). Set the AC breaker to “OFF”. c. Unplug the sockets of the electric appliances from the AC output port (or extension cord).
The mark ( ) indicates that Serious personal injury may ensue if the special tools and skills are needed and you maintenance instructions are not followed should contact Promate Service. Proper properly. maintenance is not only the basis of safe, economical and trouble-free generator operation, but also helps reduce air pollution.
7.1.a Changing engine oil (PM13000D ES) 7.1.b Changing engine oil (PM13000D ES Silent) Place a container under the drain plug to catch the oil. Use a wrench to open the Open the left door, use a wrench to release drain plug, then let the oil drain into a the drain plug (don't take out the screw), put container.
7.2 Cleaning the oil filter 7.4 Long term storage & transport Loosen the drain bolt and then pull out the oil filter. Clean every 3 months or 100 hours 1. Storage by spraying compressed air. Store the generator properly to keep the generator in good condition.
• The Company will not pay for repairs or To order replacement parts and adjustments to the product, or for any costs consumable parts, please contact Promate of labor performed without the Company's Service (details below) and be ready with prior authorization.
Need help?
Do you have a question about the PM13000D ES OPEN and is the answer not in the manual?
Questions and answers