Wireless Devices - Inner Range Inception Installation Manual

Inner Range Inception Security Controller
a delay of 10 minutes allowing time for the Wi-Fi adapter or ethernet cable to be removed
and the cabinet secured before service mode actually ends.
•
Current Status: Shows the functions disabled & the service mode expiry date & time.
To Enable or Disable Service Mode.
Operation Web Browser
-Open 'Service Mode' from the Dashboard or System Menu.
Enable
-Select 'Enable Service Mode' or 'Update Service Mode'.
Or
Update -Choose which functions to disable and the duration.
-Click on "Enable" or "Update".
-Open 'Service Mode' from the Dashboard or System Menu.
Disable
-Select 'Disable Service Mode'.
-If required, choose a 'Delay Before Disable' period.
-Click on 'Disable'.

Wireless Devices

Inception supports the Integriti Inovonics RF LAN Expander and Concept Paradox RF LAN
Expander Modules that provide an interface for RF detection devices (e.g. PIR, smoke detector,
etc), general purpose transmitters (for reed switches, etc.) and wireless remote fobs.
When RF transmitter activity is saved to the Inception review log, a signal strength value is
included in the message. This allows the installer to assess the relative signal strength of different
receiver and/or transmitter locations and the effective range of portable transmitters such as
remote fobs.
Note that the signal strength value for portable transmitters (RF fobs) is only available in the
Inception firmware release V2.0.2 or later.
© 2016 - 2020. Inner Range Pty Ltd.
8
Installation Manual. Rev. 4.0
LCD Terminal
-Logon,
-Press [MENU] [7] [1],
-Press [ON] (Enables
for 8 Hours)
-Logon,
-Press [MENU] [7] [1],
-Press [OFF]
www.innerrange.com