Inner Range INCEPTION Manual

CONNECT AND PLUG IN THE POWER CORD

WAIT FOR THE INCEPTION CONTROLLER TO START UP

• Initially, the POWER LED will turn on indicating power is being supplied to the controller
• During startup, the LEDs will light up in order from left to right to show progress
• The controller is ready when the SYSTEM LED is flashing

CONNECTING TO THE WEB INTERFACE

There are a number of options available to connect to your Inception's web interface.

• If you have purchased the Inception WiFi Expansion Module (available separately), your Inception can host an access point
• Connect the WiFi Module to the USB port on the Inception Controller
• Wait for the WIFI LED to turn on
• Use your WiFi enabled device to connect to the network. By default, the name of the WiFi network will be the panel serial number (e.g IN12345678) with the password "inception"
• Open a browser and navigate to the URL:http://inception.local

Sky Tunnel Access

• If the network your Inception Controller is connected to has internet access, you can connect to it from any internet connected device
• The SKY TUNNEL LED will be on if the Inception can contact Sky Tunnel. If this LED is not on, ensure internet access is available
• To connect, navigate to: https://www.skytunnel.com.au/inception/SERIALNUMBER/, where SERIAL NUMBER is the serial number of your Inception, found on top of the controller (e.g IN12345678)

Wired (Ethernet) connection

• Once connected, the ETHERNET LED will turn on
• To connect to the Inception web interface, the Inception's IP address is required. There are two different ways to find it the IP address:

Inception Discovery Utility

• Utility onto your computer. A copy of the application can be:https://www.innerrange.com/products/controllers/996300
• ill automatically attempt to detect Inception devices on the local network
• Select your Inception from the list and press "Open In Browser"

LOG INTO THE WEB INTERFACE

• Once connected, you will be presented with a series of Initial Configuration pages.
• Configure the Region, Timezone and the Installer User Credentials.

BEGIN COMMISSIONING

• You have successfully connected to your Inception Controller
• To commission the system, it is recommended that you use the Commissioning Checklist, which will guide you through the entire process from start to finish.

For more information, visit www.innerrange.com, there you will find installation guides and videos to help you get the most out of your Inception System.