Table of Contents
Advertisement
409-1950
2.4. Accessories
The accessories for the pump shown in Figure 3 are available separately.
The pump accepts interchangeable crimping heads, and the crimping heads accept interchangeable die
assemblies, except Crimping Head 69069 (which has self-contained dies). Use of a latch pin kit eliminates the
possibility of misplacing the standard latch pin supplied with the crimping head.
The handle control and foot control are available to operate the crimping head. If the pump is used in portable
applications, the handle control may be preferable. The handle control is available with or without a hose
assembly. The handle control is connected to the pump hydraulically (by the hose or use of the hose assembly)
and electrically (by the cordset), and the crimping head is connected to the handle control. If the pump is used
in stationary applications, the foot control may be preferable. The foot control is connected to the pump
electrically, and the crimping head is connected to the pump hydraulically (by use of the hose assembly).
The multi-directional valve allows more than one crimping head (a maximum of three or six is available) to be
operated from the pump. A separate hose assembly is needed to connect each crimping head to the multi-
directional valve and to connect the multi-directional valve to the pump. The multi-directional valve can only be
operated by the foot control.
Refer to the following paragraphs for part numbers and descriptions.
Figure 3: Accessories
7 of 22
Rev G
Advertisement
Table of Contents
