Table of Contents
Advertisement
4.4. Connecting the Accessories
CAUTION
Before installing any accessories, make sure the pump is DISCONNECTED from the power supply.
Make sure that all coupling areas of the accessories being used are thoroughly clean.
If Using the Handle Control
1. Attach the hose assembly.
If using the handle control without a hose assembly included, attach one end of the hose
assembly to the handle control and the other end to the pump (Figure 4).
If using the handle control with a hose assembly included, attach the hose assembly to the
pump (Figure 5).
2. Mate the quick-disconnect couplers and tighten the collar.
3. Attach the crimping head to the handle control according to the instructions included with the
crimping head.
4. Plug the handle control into the pump.
5. If the crimping head does not contain dies, install a die assembly onto the crimping head
according to the instructions included with the crimping head.
Figure 4: Using the handle control without a hose assembly included
Rev G
Figure 5: Using the handle control with a hose assembly included
409-1950
12 of 22
Advertisement
Table of Contents
