Table of Contents
Advertisement
If Using the Foot Control
Refer to Figure 6.
1. Attach one end of the hose assembly to the pump. Mate the quick-disconnect couplers and
tighten the collar.
2. Attach the other end of the hose assembly to the crimping head according to the instructions
included with the crimping head.
3. Plug the foot control into the pump.
4. If the crimping head does not contain dies, install a die assembly onto the crimping head
according to the instructions included with the crimping head.
Rev G
Figure 6: Using the foot control
409-1950
13 of 22
Advertisement
Table of Contents
