Checking Gear Shifting And Fine Tuning - Shimano FD-RX810 Dealer's Manual

ADJUSTMENT
Installing the inner cable and adjusting gear shifting
NOTICE
• Check that the cable is not pinched in between the outer link and input link
when the lever is released in the L-trim position.

Checking gear shifting and fine tuning

After the cable is installed and adjusted, check the gear-shift by operating the shifting lever.
If the chain falls to the crank side
If shifting is difficult from the smallest
chainring to the largest chainring
If shifting is difficult from the largest chainring
to the smallest chainring
If the chain falls to the bottom bracket side
when the gear is shifted to the lowest position
If the chain falls to the bottom bracket side
when the gear is shifted to the L-trim position
NOTICE
• First, check whether the tension of the cable is appropriate using the indicator.
• Also, perform this check if it becomes difficult to perform gear shifting during use.
Turn the top adjustment bolt counterclockwise.
Turn the top adjustment bolt clockwise.
Turn the top adjustment bolt counterclockwise.
Turn the top adjustment bolt clockwise.
Turn the low adjustment bolt clockwise.
24