Section B: Preparing The Building For Heater Installation; Section C: Mounting The Heater And Completion - L.B. White Guardian AD250 Assembly And Installation Instructions Manual

Outdoor Installation Kit
6

Section B: Preparing the Building for Heater Installation

1. Unfold the template provided in the kit.
2. Use the template for determining the proper location of the heater with its mounting brackets,
and for cutting out the hole needed for the ducting.
3. Read and comply with all installation instructions and information given on the template.

Section C: Mounting the Heater and Completion

1. After the duct hole has been cut, and stud locations identifi ed, center the wall brackets at
marks made on studs. Position the brackets so the holed mounting fl anges are pointing in
opposite directions. See Fig. 12. Temporarily attach the brackets with nails at upper holes.
See Fig. 13.
FIG. 12
FIG. 13
Nail holes
Outdoor Installation Kit • AD250 & AW250
Centered
at studs
Flanges
pointed in
opposite
directions