Step 3 - Mounting The Rails (Ladder) - Warmup HTR-4ROPO Installation Manual

Step 3 - Mounting the Rail
Ladder Rails
Components List
1A
Normal
Leg
x 3
4
Wall plugs
x 4
9
Hex key
x 1
Warmup's Ladder Towel Rails can be installed with either
concealed or exposed wiring. The instructions below
concentrate on concealed wiring.
1
• Measure and record the
resistance of the towel rails
in the "Resistance Before"
column of the control card,
supplied as part of this
installation guide.
• Stop installation immediately
and contact Warmup if its
resistance falls outside the
values set out in the resistance
table.
8
1B
Exposed Concealed
Wiring Leg Wiring Leg
x 1
5
Mounting
Wall
Screws Mount
x 4 x 3
10
Short screws
x 4
1C
Grub screws
x 1
6 7
Concealed Wiring
Wall Mount
x 1
2
• Using a long screwdriver,
screw the short screw (10)
though the leg (1A) securing it
to the towel rail body.
NOTE: The grub screw (3)
should face the floor when the
towel rail is mounted on the
wall.
2 3
M5 x 4 M5 x 6
Grub screws
x 4 x 4
Exposed Wiring
Wall Mount
x 1
8