Boot From Cd And Copy Configuration Software To Diskettes - Intel R440LX Product Manual

Boot from CD and Copy Configuration Software to Diskettes

CAUTION, handle CD only by the edges
Handle the CD only by its inner and outer edges. Do not
touch the side without the label (the data side).
1. Open the CD tray.
2. Open the CD case. Press down on the center hub of the case to release
the CD.
3. Gently grasp the center hole and outer edge of the CD. Remove it from
the case, and place it label-side up in the CD tray.
4. Close the CD tray.
5. Restart the server.
6. When POST completes, the server boots from the CD and displays the
CD-ROM menu bar. Browse to see the tasks available (create diskettes,
diagnostics, read and print manuals, quit to DOS). If the following
message appears,
Insert bootable media in the appropriate drive
you may need to change the BIOS setup to boot from CD. See "Boot
Menu" on page 68. Set the first boot device to CD-ROM, the second to
diskette, and the third to hard disk.
7. Select the option Create Diskettes. Make sure you have several
diskettes on hand.
8. Follow the prompts to copy the SCU software from CD onto diskettes.
You must have the SCU on diskette when you start to configure the
server.
28
A
Typical
CD-ROM drive
A
B
B
OM05063
Chapter 2 - Configuring the System
Open/close
push-
button
switch
CD tray,
CD with
label side
up