Table of Contents
Advertisement
3
Attach the cover to the basic processing unit. Plug the power cable to the outlet.
4
Turn on the basic processing unit.
5
When the SCSI bus can be set on the side of the basic processing unit, set the following on the
Built-In AIT.
• Transfer rate
• Data bus width
• DISCONNECT/RECONNECT function
For details, see the instruction manual provided with the basic processing unit.
Important
Set the maximum transfer rates as follows according to the number of devices connected to the
bus and the SCSI cable length.
The following are standard values.
If you have other specifications at your disposal, use them over the ones below.
SCSI ID
Ultra Wide SCSI
Ultra Wide SCSI
Ultra Wide SCSI
Fast Wide SCSI
Wide SCSI
* When the SCSI host and all devices connected to the same bus are LVD-compatible.
Installing the tape device driver
Only install the device drive if you intend to use Windows 2000 Backup, Windows XP Backup, or
Windows Server 2003 Backup (found in their respective System Tools folder).
Install the device driver in the basic processing unit with the supplied floppy disk. Prepare the
floppy disk beforehand.
Maximum transfer
rate (Mbyte/s)
40
40
40
20
10
: 40 Mbyte/second (max., synchronous)
: 16 bits (Ultra Wide SCSI, LVD/SE)
: Enable
Data bus
Maximum cable Maximum number
width (bit)
length (m)
Single-ended
16
3
16
1.5
16
-
16
3
16
6
of devices
(SCSI host +
LVD*
number of devices)
-
4
-
8
3
16
3
16
3
8
Built-in AIT 85
Advertisement
Chapters
Table of Contents
