Table of Contents
Advertisement
4
Remove the data cartridge from the
slot and close the dust cover.
• When the TAPE MOTION LED is lit or blinking, do not turn off the basic processing unit. This
may cause a malfunction or damage data.
• To avoid malfunction, do not transport this unit with the data cartridge installed.
• Eject the data cartridge when you are done performing a backup.
LED indication
Three LED on the Built-In AIT's front side signal the status of the drive and the AIT data
cartridge.
LED
TAPE MOTION
OFF
No data cartridge set.
ON
Data cartridge set.
Blink (Slow)
Set data cartridge
operating normally (low
speed).
Blink (Fast)
Set data cartridge
operating normally (high
speed).
All LED:
Malfunction
Blink (Fast)
Blink (Fast)
: 0.3 s ON, 0.3 s OFF
Blink (Slowly)
: 0.9 s ON, 0.3 s OFF
Reading/writing data
To read/write the data from/to the AIT data cartridge, see the instruction manual provided with the
backup application.
98 Built-in AIT
CLEANING REQUEST
Built-In AIT does not
need cleaning.
Built-In AIT needs
cleaning.
Cleaning head or
cleaning cartridge tape
ended.
-
REPLACE TAPE
No data cartridge error.
Data cartridge error.
-
-
Advertisement
Chapters
Table of Contents
