System Requirements; Hardware Description - SMC Networks EZ Connect g Quick Installation Manual

System Requirements

To use the EZ Connect TM g Wireless Ethernet Bridge,
you must have:
• A web browser, such as Microsoft Internet Explorer 5.5 or above
installed on one PC at your site for configuration of the Wireless
Ethernet Bridge.
• A CD-ROM drive.
• An AC power outlet to supply power to the Wireless Ethernet
Bridge.
• A Wired or Wireless Network Adapter.
• An available RJ-45 (UTP) port on an Ethernet hub or switch.
• A TCP/IP network protocol installed on each PC that needs
to access the Internet.
3

Hardware Description

The EZ Connect™ g Wireless Ethernet Bridge supports high speed
communication up to 54Mbps. It incorporates support for PRISM
Nitro which provides enhanced throughput and range. This device
is fully compliant with 2.4GHz DSSS and OFDM CSMA/CA wireless
networking as defined in IEEE 802.11b and 802.11g. It can be
connected via an RJ-45 connection to devices such as Nintendo
GameCube, Microsoft Xbox, Sony PlayStation II, and Ethernet ready
embedded devices. It can also function as an IEEE 802.11g Access
Point, giving you the capability of creating a new 802.11g wireless
network. In addition, this product supports Wireless Distribution
System (WDS) for repeater functionality to extend the range
of your wireless network.
LED Status
Power On (Green)
Off
Wireless LAN Blinking (Green)
On (Green)
Off
LAN Blinking (Green)
On (Green)
Off
Function
Power on.
No Power.
Wireless LAN connection
is transmitting.
Wireless LAN connection
is active.
Wireless LAN connection
is not active.
Wired LAN connection
is transmitting.
Wired LAN connection
is active.
Wired LAN connection
is not active.
4