Mounting Behind Basketball Backboard (Bt6008) - Bodet BT6002 Installation And User Manual

X - Mounting behind basketball backboard (BT6008)
For each 24 second display, the mounting kit is supplied with :
- 1 support mast
- M10x185 threaded shafts
- M10x90 bolts
1/ According to the type of basketball boards, extend the support mast (60 × 30 tube) for each display
until it reaches the final position (regulation distance for dimensions L).
2/ Fix the shoe with 4 threaded shafts + flat washers and plywood to the arm of the basketball goal
(See D).
3/ Fix the 2 U sections to the mast (level depending on model).
4/ Position the mast in the shoe with 1 HM10×90 screw, 1 HU M10 nut and Ø10 flat washer.
5/ Rotate the mast vertically, then lock it with a HM10×90 screw, 1 HU M10 nut and Ø10 flat washer to
the opening of the shoe.
6/ Fix the display to the mast with H M10x60 bolts, HU M10 nuts, Ø10 flat washers and Ø10 washers
(B).
7/ Check the distance L (30 to 50 cm). Once the panel is in the right position, drill all the way through
the mast tube (Ø11) and fit in a HM10×90 screw, 1 HU M10 lock nut and Ø10 flat washer to hold the
panel in its final vertical position.
A
A
A A
HM10x90 screw
Ø10 flat washer
HU M10 nuts
M10x185 threaded shaft
Ø10 flat washer
HU M10 nuts
24
- 1 shoe
- H M10 x 90 screws
- H M10x50 screws
Pivot axis
arm of the basketball goal
(100 to 140 square tube).
- 2 U sections
- HU M10 nuts
- Ø10 flat washers
B
B
Drill through the tube to Ø11 in the vertical position
to hold the display unit in the fixed and final position.
With 1x H M10x90 screw and 1x HU M10 nut.
B
- Ø12 flat washers
- plywood