Table of Contents
Advertisement
a
&,Safety Instruction
These instructions are intended to ensure that the user can use the
product correctly to avoid danger or property loss.
Laws and Regulations
The device should be used in compliance with local laws, electrical
safety regulations, and fire prevention regulations.
Transportation
Keep the device in original or similar packaging while transporting it.
Power Supply
The input voltage should conform to IEC60950-1 standard: SELV
(Safety Extra Low Voltage) and the Limited Power Source. Refer to
the appropriate documentation for detailed information.
DO NOT _connect multiple devices to one power adapter, to avoid
over-heating or fire hazards caused by overload.
Make sure the plug is properly connected to the power socket.
System Security
The installer and user are responsible for password and security
configuration and its settings.
Battery
-
Improper use or replacement of the battery may result in explosion
hazard. Replace with the same or equivalent type only. Dispose of
used batteries in conformance with the local codes.
Maintenance
If the product does not work properly, please contact your dealer or
the nearest service center. We shall not assume any responsibility for
problems caused by unauthorized repair or maintenance.
-
A fe\11_ device components'
(e._
g ., electrolytic capacitor) require regular
replacement. The average lifespan vanes, so periodic checking is
recommended. Contact your dealer for details.
Cleaning
Please use a soft and dry cloth when clean inside and outside
surfaces of the product cover. Do not use alkaline detergents.
Using Environment
When any laser equipment is in use, make sure that th; device lens is
not exposed to the laser beam, or it may burn out.
e the device to high electromagnetic radiation or dusty
�ivi �g � �:�: _
For indoor-only device, place it in a dry and well-ventilated
environment.
Do not aim the lens at the sun or any other bright light.
Make sure the running environment meets the requirement of the
device. The operating temperature shall be -30 °C to 60 °C (-22
°F to 140 °F), and the operating humidity shall be 90% or less (no
condensing).
Do not place the camera in extremely hot, cold, dusty or damp
locations, and do not expose it to high electromagnetic radiation.
Emergency
If smoke, odor, or noise arises from the device, immediately turn off
the power, unplug the power cable, and contact the service center.
Time Synchronization
Set up camera time manually for the first time access if the local time
is not synchronized with that of the network. Visit the camera via Web
browse/client software and 9_? to time settings interface.
Installation
Make sure the device is firmly secured to any wall or ceiling
mountings.
Be sure that there is enough space to install the camera and
accessories.
Make sure that the device in the package is in good condition and all
the assembly parts are included.
Make sure that the wall is strong enough to withstand at least 4 times
the weight of the camera and the mount.
The standard power supply is 12
or PoE (802.3at), please make
VDC,
sure your power supply matches with your camera.
Make sure that the power has been disconnected before you wire,
install, or disassemble the device.
Make sure that no reflective surface is too close to the camera lens.
The JR light from the camera may reflect back into the lens causing
reflection.
Symbols and Marks
��
Notice
&
Warning
0
Forbidden
.,/
Correct
X
Incorrect
(B
Turn to page A and continue.
i. Not necessarily included accessory.
ii. Variable accessory amount.
iii. Skip this step if not required.
MicroSD card
microsoa
Grounding
�
- Wj
Disposal
Purchase separately
�
lx
0
2x*
lx
1.2
microsoa
- · �
·
�
·
�
@�
lx
@
i
�
lx
lx
lx
lx
lx
Advertisement
Table of Contents
