Dismounting - Abicor Binzel MT 452 W Operating Instructions Manual

11 Dismounting

11 Dismounting
EN - 20
Dismounting may only be carried out by specialised personnel. Please make
sure that the shutdown procedures are strictly observed, before the dismounting
work begins. Ensure this also for the components integrated into the welding
system.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Cut off the gas supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTE
• Observe the information given in 8 Removal from service on
page EN-17.
1 Disconnect the welding torches from the power supply.
2 Remove worn parts.
MT/AUT/AUT RAB