Icom IFC-30LT Manual page 25

THE SELECTION OF A « BANK » IS DONE BY PRESSING
IF YOU WANT TO SAVE YOUR FREQUENCY ON CHANNEL 5 OF « BANK » 2, YOU
WILL HAVE TO SELECT « BANK » 2 USING
DISPLAYED IN THE TOP LEFT CORNER.
NOTE FOR USING CHANNELS STORED IN BANKS you will have to select the correct
P 1
bank by pressing
to channel 5 to transmit and receive on this channel.
IF YOU WANT TO SAVE YOUR FREQUENCY ON « BANK » 1, THE SELECTION OF THE
BANK WILL STILL HAPPEN USING
BUTTON UNTIL NO FIGURE APPEARS ON THE TOP PART OF THE DISPLAY
INDICATING YOU ARE IN
5 SELECT A CHANNEL NUMBER
Example CHANNEL 8
KEY IN
6 PRESS SIMULTANEOUSLY ON
TO ENTER THE TOT PROGRAMMING MODE
7 TO ENABLE OR DISABLE THE TOT
PRESS
8
PRESS
9 TURN TRANSCEIVER OFF
10 THE CHANNEL IS NOW PROGRAMMED WITH THE
TOT FUNCTION
Guideline Télécom MSFB
(
« bank » 2 in our example) and then rotate the channel selector
P 1
BUT YOU WILL HAVE TO PRESS THIS
« BANK » 1.
0 8
CONFIRM USING
7
AND
+
Po
TWICE TO CONFIRM
Technical Sheets
P 1
P 1
AND CHECK THAT FIGURE 2 IS
ICOM IC-F30 LT
CH 08
TOT ON
TOT OFF
SET MODE
25
05/08/2002