Icom IFC-30LT Manual page 23

WILL HAVE TO SELECT « BANK » 2 USING
DISPLAYED IN THE TOP LEFT CORNER.
NOTE FOR USING CHANNELS STORED IN BANKS you will have to select the correct
P 1
bank by pressing
to channel 5 to transmit and receive on this channel.
IF YOU WANT TO SAVE YOUR FREQUENCY ON « BANK » 1, THE SELECTION OF THE
BANK WILL STILL HAPPEN USING
BUTTON UNTIL NO FIGURE APPEARS ON THE TOP PART OF THE DISPLAY
INDICATING YOU ARE IN
5 SELECT A CHANNEL NUMBER
Example CHANNEL 8
KEY IN
6 PRESS SIMULTANEOUSLY ON
TO ENTER OUTPUT POWER PROGRAMMING
7 SELECT OUTPUT POWER BY PRESSING
ONCE
TWICE
THREE TIMES
8 CHOOSE HIGH OUTPUT POWER
9
PRESS
10 TURN TRANSCEIVER OFF
11 YOUR CHANNEL IS NOW PROGRAMMED TO BE
TRANSMITTING WITH HIGH OUPUT POWER
Guideline Télécom MSFB
(
« bank » 2 in our example) and then rotate the channel selector
P 1
BUT YOU WILL HAVE TO PRESS THIS
« BANK » 1.
0 8
CONFIRM USING
8
AND
AND
PWR LO1
PWR LO2
PWR HI
Po
TWICE TO CONFIRM
Technical Sheets
P 1
AND CHECK THAT FIGURE 2 IS
ICOM IC-F30 LT
CH 08
PWR HI
PWR LO1
PWR LO2
PWR HI
SET MODE
23
05/08/2002